+
  • 6.jpg

Anti static flat coating

This product is an improved anti-static material based on solvent-free epoxy flat coating topcoat, and is also a two component solvent-free floor paint. It consists of two parts: A component (color paint) and B component (curing agent), forming a wave coating type coating. It has high solid content, good wear resistance, strong hardness, good film fullness, good flowability, excellent conductivity, and permanent anti-static properties. The surface resistance and volume resistance of the anti-static value can both reach 1x104-1x109. High cost-effectiveness.

Details

1、 Product Introduction
This product is an improved anti-static material based on solvent-free epoxy flat coating topcoat, and is also a two component solvent-free floor paint. It consists of two parts: A component (color paint) and B component (curing agent), forming a wave coating type coating. It has high solid content, good wear resistance, strong hardness, good film fullness, good flowability, excellent conductivity, and permanent anti-static properties. The surface resistance and volume resistance of the anti-static value can both reach 1x104-1x109. High cost-effectiveness.
2、 Usage method
(1) Before use, component A (paint) should be thoroughly stirred with an explosion-proof mixer, and high-speed stirring for 1-3 minutes is suitable. For precipitation caused by long-term storage of component A (paint), it must be stirred evenly before use.
(2) A component (paint) and B component (curing agent) should be weighed using a standard measuring device according to the proportion indicated on the packaging label to ensure their accuracy. After mixing, they should not be mixed randomly to avoid affecting the curing effect of the material.
(3) The mixed AB components must be stirred evenly with a high-speed mixer, usually for 2-3 minutes. The best method is to construct the mixed material at a temperature above 25 ℃ and use it within 20 minutes. The shorter the storage time, the better the effect after use.
(4) Fill the material with a pre prepared drum and evenly roll it onto the ground. Generally, it should be scraped and applied to the ground for the first time and completely cured (when the material is dry), and then evenly roll it for the second time to achieve color consistency.
3、 Precautions:
(1) This product belongs to flammable chemicals. Please stay away from ignition sources and use explosion-proof motors for the mixer.
(2) This product should be stored in a cool and ventilated place and should not be exposed to the sun.
(3) Do not use this product at a temperature below 5 ℃ for construction, as low temperatures can affect the curing time. The humidity should not exceed 70%, as excessive humidity can cause whitening and uneven color on the surface of the paint film.
(4) When used at low temperatures, if the material viscosity is high, a special diluent can be added at a rate of 2-3% of the total AB mixing amount for use.
(5) During the construction process, if materials are accidentally splashed into the eyes, they should be promptly rinsed with clean water and sent to the hospital for treatment.

Other Products

I want to consult

Submission